tekmolding017218014017.gif
tekmolding017218014016.gif
tekmolding017218014015.gif
tekmolding017218014014.gif
tekmolding017218014013.gif
PAGE 2 OF 2
TEK Molding, LLC
Home of Kennecorp and Prenco-TypeŽ Divisions
tekmolding017218014012.gif
tekmolding017218001001.gif
Home of
tekmolding017218014010.gif
PREVIOUS PAGE
PAGE 2 OF 2
tekmolding017218014009.gif
tekmolding017218014008.gif
5036tran.gif
tekmolding017218014007.gif
tekmolding017218013013.gif
tekmolding017218013013.gif
tekmolding017218013013.gif
tekmolding017218014006.gif
tekmolding017218013012.gif
Figure 4
tekmolding017218014005.gif
tekmolding017218014004.gif
tekmolding017218014003.gif
tekmolding017218014002.gif
tekmolding017218013012.gif
Figure 5
tekmolding017218014001.jpg
Figure 6
tekmolding017218013012.gif
Figure 7
Thumb Screw
Protective paper lined adhesive
Type cutting operation is repeated until desired line of letters, numbers or symbols is completed. Center type in the Chase, loosen winged thumb screw, Figure 4, and remove Chase from Cutting Device.
Lay Chase face down on flat surface. Slide back and pivot the cover away from Chase to expose back side of Type, Figure 5.
Apply Double Sided Pressure Sensitive Tape to the special Plastic Type Holder, cut tape off evenly at both ends of holder, then with knife, separate and peel off paper liner from adhesive.
Insert Plastic Type Holder over type in groove of Chase. Press Holder down on type (bonding type of holder), Figure 7. Lift from Chase and Stamp is ready for use.

Note: Double or multiple line stamps are made by snapping interlocking plastic type holders together.
Return to Menu
b-norm2.gif
Page Last Modified 3/2/18 by Lori Kooger@tekmolding.com