tekmolding017218016013.gif
tekmolding017218016012.gif
tekmolding017218016011.gif
tekmolding017218016010.gif
tekmolding017218016009.gif
PAGE 2 OF 2
TEK Molding, LLC
Home of Kennecorp and Prenco-TypeŽ Divisions
tekmolding017218016007.gif
PREVIOUS PAGE
tekmolding017218016006.gif
tekmolding017218001001.gif
Home of
PAGE 2 OF 2
tekmolding017218013013.gif
5014tran.gif
tekmolding017218013012.gif
Figure 4A
5015tran.gif
tekmolding017218015001.gif
Figure 5
tekmolding017218013013.gif
5016tran.gif
tekmolding017218016004.gif
Figure 6
tekmolding017218016005.gif
tekmolding017218013013.gif
tekmolding017218016004.gif
Figure 7
Apply double side pressure sensitive tape to the special plastic type holder, cut tape off evenly at both ends of holder, then with knife, separate and peel off paperliner from adhesive, Figure 5.
Lay adapter face down on a flat surface, Figure 4A.

Slide back and pivot the cover away from adapter to expose back side of type, Figure 4B.
Figure 4B
Slide and adjust type in adapter using scale provided for centering or line-up purposes.

Press prepared holder firmly down on type, Figure 6. Lift up holder with type adhered thereon. Stamp is now ready for use.
By snapping together the interlocking platic holders, multiple line stamps can be made on the spot.
Note: Since multiple line stamps are made on individual holders, it is important to pick up type from adapter with the type holders facing in the same direction each time. This will avoid up-side-down lines in stamps.
tekmolding017218016003.gif
Figure 4B
tekmolding017218016002.gif
tekmolding017218016001.gif
Protective paper lined adhesive
Return to Menu
b-norm2.gif
Page Last Modified 3/2/18 by Lori Kooger@tekmolding.com