tekmolding017218021009.gif
tekmolding017218021008.gif
tekmolding017218021007.gif
tekmolding017218021006.gif
tekmolding017218021005.gif
Material Name: Stamping Ink
Trade Name: C-100-1 Paste Ink
Part Number: I-8-WHO White
Material Safety Data Sheet
Supplier Name, Address, and Tel. No.:
TEK Molding, LLC
PO Box 735
Vernon, NJ 07462

Tel. (973)702-0450
Fax (973)702-0448
HMIS Codes:
tekmolding017218021001.gif
HAZARDOUS INGREDIENTS
Hazardous Components
Occupational Exposure Limits
CAS Number OSHA PEL ACGIH TLV
Vapor Pressure
Weight
Percent
mm Hg @ TEMP
tekmolding017218021004.jpg
*Dimethyl Phthalate
131-11-3
1.0
212F
27
* Indicates toxic chemical (s) subject to the reporting requirements of section 313 of Title III and of 40 CFR 372
tekmolding017218021001.gif
PHYSICAL/CHEMICAL CHARACTERISTICS
b-norm2.gif
Return to Prenco-TypeŽ Marking Inks
Boiling Range:
Vapor Density:
Material V.O.C.: 4.03 LB/GL (483 G/H)
Solubility in Water:
Appearance and Odor:
543 Deg F
Heavier than air


Specific Gravity:
Evaporation Rate:
(H20=1): 1.8
Slower than Ether

tekmolding017218021001.gif
FIRE AND EXPLOSION HAZARD DATA
Insoluble
Viscous colored liquid, mild characteristic odor.
5 MG/M3
5 MG/M3
H
2
F
1
R
0
P
Material Name: Stamping Ink
Trade Name: C-100-1 Paste Ink
Part Number: I-8-WHO White


Prepared For:
PO Number:
Date:
Flash Point: 315 Deg F
Flammable Limits in air by volume- LOWER: N/A UPPER: N/A
Extinguishing Media: Alcohol, foam, CO2, Dry chemical, Water Fog
Special Firefighting Procedures: Water may be used to close containers to prevent explosion when exposed to extreme heat. Full protective equipment may be needed to protect firefighters from hazardous combustion products.
Unusual Fire and Explosion Hazards: During emergency conditions, overexposure to decomposition products may cause a health hazard.
Method Used: Open Cup
PAGE 1 OF 2
PAGE 1 OF 2
NEXT PAGE
tekmolding017218021002.gif
tekmolding017218021001.gif
REACTIVITY DATA
Stability: Stable Conditions to avoid: NONE
Incompatibility(Materials to avoid): Contact with strong acids, alkalies, or oxidizers.
Hazardous Decomposition or By Products: may produce Carbon Monoxide, Carbon Dioxide, and other hazardous decomposition products.
Hazardous Polymerization: Will not occur
Page Last Modified 3/2/18 by Lori Kooger@tekmolding.com