tekmolding017218023008.gif
tekmolding017218023007.gif
tekmolding017218023006.gif
tekmolding017218023005.gif
tekmolding017218023004.gif
Material Name: Stamping Ink
Trade Name: C-100-1 Paste Ink
Part Number: I-6-BKO Black
Material Safety Data Sheet
Supplier Name, Address, and Tel. No.:
HMIS Codes:
b-norm2.gif
Return to Prenco-TypeŽ Marking Inks
H
2
F
1
R
0
P
Material Name: Stamping Ink
Trade Name: C-100-1 Paste Ink
Part Number: I-6-WHO Black


Prepared For:
PO Number:
Date:
PAGE 1 OF 2
tekmolding017218021001.gif
HAZARDOUS INGREDIENTS
Hazardous Components
Occupational Exposure Limits
CAS Number OSHA PEL ACGIH TLV
Vapor Pressure
Weight
mm Hg @ TEMP
tekmolding017218023003.jpg
*Dimethyl Phthalate
131-11-3
1.0
212F
36
* Indicates toxic chemical (s) subject to the reporting requirements of section 313 of Title III and of 40 CFR 372
5 MG/M3
5 MG/M3
*Diethylene Glycol Monobutyl Ether
112-34-5
N/A
N/A
0.1
77F
5
tekmolding017218021001.gif
PHYSICAL/CHEMICAL CHARACTERISTICS
Boiling Range:
Vapor Density:
Material V.O.C.: 4.60 LB/GL (551 G/H)
Solubility in Water:
Appearance and Odor:
Specific Gravity:
Evaporation Rate:
(H20=1): 1.3
Slower than Ether

446 to 543 Deg F
Heavier than air


Insoluble
Viscous colored liquid, mild characteristic odor.
tekmolding017218021001.gif
FIRE AND EXPLOSION HAZARD DATA
Flash Point: 222 Deg F
Flammable Limits in air by volume- LOWER: 0.9% UPPER: N/A
Extinguishing Media: Alcohol, foam, CO2, Dry chemical, Water Fog
Special Firefighting Procedures: Water may be used to close containers to prevent explosion when exposed to extreme heat. Full protective equipment may be needed to protect firefighters from hazardous combustion products.
Unusual Fire and Explosion Hazards: During emergency conditions, overexposure to decomposition products may cause a health hazard.
Method Used: Closed Cup
tekmolding017218021001.gif
REACTIVITY DATA
Stability: Stable Conditions to avoid: NONE
Incompatibility(Materials to avoid): Contact with strong acids, alkalies, or oxidizers.
Hazardous Decomposition or By Products: may produce Carbon Monoxide, Carbon Dioxide, and other hazardous decomposition products.
Hazardous Polymerization: Will not occur
NEXT PAGE
tekmolding017218023001.gif
PAGE 1 OF 2
TEK Molding, LLC
Page Last Modified 3/2/18 by Lori Kooger@tekmolding.com
PO Box 735
Vernon, NJ 07462

Tel. (973)702-0450
Fax (973)702-0448